Tri stick conversion for DC/DS 14-16-24 Jeti Radios

This is not a Jeti Model product, it has been around for a few years and was originally developed by Mike Ridley and with his blessing and the help of the manufacturer has been adjusted for Jeti transmitters.

This can be used as a Tri stick so you can have the main controls on one stick Elevator, Ailerons and Rudder, this is a fully proportional unit that can be calibrated as with any other proportional control.

This can be used for many other devises as in RC diggers for rotation control of the cab, or anywhere that requires proportional control.

This is wired into the radio the same as the Jeti stick switch units using the dedicated soldering pads on the stick unit that have three wires into the main board

The existing shaft has to be removed from the gimbal then the Tri stick unit screws into the gimbal, the wires are then located as per Jeti model instructions.

Please note, this tri stick unit can not be used with the DS12 as any proportional control can not be calibrated using the MSW Expantion Module 

The tri unit is center sprung, so once fitted you can use the calibration settings on the TX to set up full movement and centre position.