MAV Sense Voltario T30

MAV Sense Voltario T30

Voltario T30 combines the touch switch function with the telemetry sensor for your model in a single device.

Voltario T30 is suitable for switching the electronics in your model on and off. When using a receiver battery, the Voltario T30 can directly replace the mechanical switch. Especially with thin glider fuselages or models that are equipped with a small BEC circuit, the device offers great advantages in addition to monitoring the receiver power supply, such as its small size. The device remembers its last operating status and restarts automatically after connecting the power supply.

• Touch switch function
• Duplex telemetry (current, voltage, capacity)
• HOTT telemetry (current, voltage, capacity)
• Futaba Telemetry (1678 Port3 - Current, Voltage, Capacitance)
• Optional undervoltage lockout 
• JetiBox compatible

Voltario T30 installation:

Plug the device between the receiver and the battery. If you are using a BEC, plug the Voltario between the battery and the BEC. Remember that in this case you have to unplug the red wire from the Voltario telemetry connector.

Touch switches:

Place the touch button anywhere on your model on the non-conductive material surface. You can also place the touch button in the fuselage with a maximum thickness of up to 3mm

• The status LED should be visible outside the fuselage.
• Stick the "Touch" sticker on the touch surface
• Connect the receiver battery to the Voltario and briefly touch the button.
• The status LED should blink once. If not, please increase the touch sensitivity parameter in the configuration
• Touch and hold the button for about 2 seconds. After the first flash, the LED starts flashing again.
• At this moment, release the button. The main output is now activated: